Congrats, she look like a BEAST!!!! Did you happen to put on a PCV? or using a PCIII? Either way would it be possible to share your Mapping they setup for you? I have a similar setup and I want a good starting point if possible..
Thanks man, it really pulls hard. It has a PCV. Unfortunately, I don't know what the mapping is because they did all the tuning. My DIY skills are only at the bolt-on/oil change level for any bike with EFI so I am afraid I am not of much use when it comes to this stuff. Although my dyno sheet looked a bit low when compared to the ones posted on www.raiderperformance.com
with the same setup (VH 2 into 1, PCV, and PRBAK), the air to fuel ratio is perfect throughout and the torque curve is incredibly linear. At the end of the day, this is what I was looking for so I won't get hung up on the numbers. Could have been the 240mm rear tire, weather, who knows that had the numbers low but the bottom line is that I trust that the dyno tune was done as well as it could have been done and the bike feels fantastic. At 65 in 5th it sounds like it is idling on its side stand and it pulls like a turbine all throughout the gear range in all gears. Very happy!