What I haved Learned About Installing Autotune on V&H 2-1 Pipes

[Scoob]

On the VH 2-1 you have to weld bung in 1" back from the center of existing  bung and at about 1 oclock position on your pipe when looking at the pipe from the front of the bike

[t84a]

No chance. Did the 2-1 come with the bung already in or did my dealer weld one on!

[Scoob]

My pipes came with an existing bung for the stock O2 senser

[t84a]

Was it in the location mine is because mine's real close to the "1"

[Scoob]

It would end up about right on the weld where pipe tees off to work . I personally just welded mine in right below the bung  that was in  pipes when I bought them but then its not at the correct angle that was recommended in the instructions but I havent had any issues with it

Where I have pipe marked with black marker is where I think you need to weld the bung in and not hit anything with O2 sensor.
Anyone else who has welded one in is more than welcome to confirm if this is right or not