Onboard diagnostic

[Brianheartline]

Bike shows one code according to these instructions, code is 0.  I can't find what this is anywhere.  Anyone have suggestion?

You have to scroll way down the list to #61. this is where you'll find the codes if there are any. #62 tells you how many time you have gotten these codes


61 Malfunction history code
display
—
• No history 00
• History exists Fault codes 12-70
• (If more than one code
number is detected, the display
alternates every two
seconds to show all the detected
code numbers.
When all code numbers are
shown, the display repeats
the same process.)

62 Malfunction history code
erasure
• No history 0 —
• History exists Up to 25 fault codes To erase the history, set the
engine stop switch to “ ”.

[RoadStarRaider]

[midnight_raider]

62 shows 1
63 shows 00
70 shows 0

[Brianheartline]

62 shows 1
63 shows 00
70 shows 0

Okay #62 is the number of times the code is in there, #61 shows the code

[midnight_raider]

61 shows 00

[Brianheartline]

61 shows 00

Okay I take that as no codes are there. I would reset it and just pay attention if the check engine light comes back on.

[midnight_raider]

OK.  Thanks

[midnight_raider]

Bike shows the code without going into diagnostic mode now. 

[Brianheartline]

Bike shows the code without going into diagnostic mode now.

This code shows up with the key on and the bike not running? What is the code#

[midnight_raider]

Yes, code 34.  Ground wire was disconnected on one of the coils.

[Brianheartline]

Yes, code 34.  Ground wire was disconnected on one of the coils.

Did you get it fixed

[midnight_raider]

Yep, while the bike was in for first service.  Guessing maybe it was loose from the factory and vibrated the rest of the way over 600 miles. 

[Brianheartline]

Yep, while the bike was in for first service.  Guessing maybe it was loose from the factory and vibrated the rest of the way over 600 miles. 

Or they loosened it for you. I try do do everything I can myself. I have this problem that whenever I pay somebody to work on my stuff something always happens. It dosen't get fix right or something happens that shouldn't happen. Glad all is good now.

[midnight_raider]

Being new to the Raider I'm letting the dealer do the maintenance for awhile.  I previously had an R1 and did all the maintenance so that I always knew what to expect from the bike. So far Tejas has been good to me.

[spider]

my book says #18 code means the exup servo motor is stuck or short circuit in wire harness,,,now what you need to do I have no idea

[Brianheartline]

my book says #18 code means the exup servo motor is stuck or short circuit in wire harness,,,now what you need to do I have no idea

If you have removed the servo for aftermarket exhaust there is a thread in this forum about it. Cant remember what its called or who makes it. I'm sure someone will chime in here in a few and help me remember.